2150cc FIC BMW x40i Injector Set (High-Z)

$1,355

In stock. Allow 1 business day for processing before shipment.

BMW x40i Fuel Injector Clinic Injector Set to fit aftermarket intake manifold or port injection kit: 6x2150cc High Impedance Ball & Seat Injectors. These injectors utilize the latest technology and provide great linearity and short pulse width repeatability. Includes pigtails PGTDEN6 or add PADPDtoU6. This injector set is precisely matched using Fuel Injector Clinic's proprietary Data Match Technology . Each injector is individually serial numbered and the results are provided on the Data Match Sheet providing the most complete flow matching and latency value information available in the industry today. Fuel Injector Clinic injectors are flow tested and rated at 43.5psi (3Bar) at 90deg F fuel temperature using CF-16B calibration fluid. Superior short pulse width control and state of the art matching make these injectors easy to tune and provide great drivability. Fuel Injector Clinic injectors are set up to and include all o-rings needed to fit the factory application for the listed vehicle. Contact TurboGixxer before ordering to confirm injector fitment for aftermarket or unusual setups. Every injector is covered against failure caused by defects in original manufacture by Fuel Injector Clinic's lifetime warranty. This massive high performance injector is in a class of its own when low end throttle response and short pulse width control is required. State of the art Data Match Technology dynamic flow matching is used during the production of these injector sets due their large flow rate. This significantly improves the ECU’s ability to control these injectors in the sub 2ms pulse width area, typical of idle and part throttle conditions. Each injector is individually serial numbered and the results are provided on the Data Match Sheet providing the most complete flow matching and latency value information available in the industry today. Fuel Injector Clinic injectors are flow tested and rated at 43.5psi (3Bar) at 90 degrees F fuel temperature using CF-16B calibration fluid. CAUTION! The internal construction of this 2150cc/min injector includes a seal that has been found to swell when in contact with MTBE from oxygenated fuels like Q16 or VP Import. This swelling causes a significant reduction in flow through the injector and therefore renders it unsuitable for use with MTBE oxygenated fuels. Please be sure to follow the care instructions for these injectors since there are potential corrosion issues that may arise from prolonged disuse while exposed to alcohol based fuels (E85, etc.)

Make

BMW

Flow rate

2150 cc/min

Set size

6 injectors

Impedance

High-Z

Aspiration

Turbocharged

Injector height

38mm

Top O-ring

14mm

Bottom O-ring

14mm

Reference pressure

43.5 psi