650cc FIC Mitsubishi DSM or EVO 8/9 Injector Set (High-Z)

$378

In stock. Allow 1 business day for processing before shipment.

Mitsubishi DSM/Evo Fuel Injector Clinic Injector Set: 4x650cc Saturated / High Impedance Ball & Seat Injectors. These injectors utilize the latest technology and provide great linearity and short pulse width repeatability. Requires pigtails PGT USC4 or Plug & Play adaptors PADPUtoJ4. Resistor pack removal recommended. Fuel Injector Clinic's high performance fuel injector sets are precisely flow matched to within 1%. Each injector within each set is individually numbered and results for each injector are listed on a detailed flow sheet included with the set. Fuel Injector Clinic's high performance fuel injectors are flow tested and rated at 43.5psi (3Bar) at 90 degrees F fuel temperature using CF-16B calibration fluid. Superior short pulse width control and tight manufacturing tolerances make these injectors easy to tune and provide great drivability. Fuel Injector Clinic injectors are set up to and include all o-rings needed to fit the factory application for the listed vehicle. Contact TurboGixxer before ordering to confirm injector fitment for aftermarket or unusual setups. Every injector is covered against failure caused by defects in original manufacture by Fuel Injector Clinic's lifetime warranty. This set of injectors requires you to change the injector plug on the wiring harness in your car. This can be done by soldering in the pigtails (included with purchase) to replace the plugs currently on your harness, or you can choose to purchase the optional plug-n-play adaptors which will convert from the type of plugs on these injectors to the plugs on your harness without any need for cutting or soldering. This plug conversion is made necessary because FIC always chooses to provide brand new, unused injectors for its performance applications.

Make

Mitsubishi

Flow rate

650 cc/min

Set size

4 injectors

Impedance

High-Z

Aspiration

Turbocharged

Injector height

64mm

Top O-ring

11mm

Bottom O-ring

16mm Square seal

Reference pressure

43.5 psi