2150cc Honda/Acura NSX (90-05) Injector Set (High-Z)

$1,355

In stock. Allow 1 business day for processing before shipment.

Honda/Acura NSX (90-05) Fuel Injector Clinic Injector Set: 6x2150cc Saturated / High Impedance Ball & Seat Injectors. These injectors utilize the latest technology and provide great linearity and short pulse width repeatability. Includes pigtails PGT DEN6 or add Plug & Play adaptors PADPDtoJ6 (1990-2005 All 3.0L) or PADPDtoH6(1997-2005 ALL 3.2L) Fuel Injector Clinic's high performance fuel injector sets are precisely flow matched to within 1%. Each injector within each set is individually numbered and results for each injector are listed on a detailed flow sheet included with the set. Fuel Injector Clinic's high performance fuel injectors are flow tested and rated at 43.5psi (3Bar) at 90 degrees F fuel temperature using CF-16B calibration fluid. Superior short pulse width control and tight manufacturing tolerances make these injectors easy to tune and provide great drivability. Fuel Injector Clinic injectors are set up to and include all o-rings needed to fit the factory application for the listed vehicle. Contact TurboGixxer before ordering to confirm injector fitment for aftermarket or unusual setups. Every injector is covered against failure caused by defects in original manufacture by Fuel Injector Clinic's lifetime warranty. This massive high performance injector is in a class of its own when low end throttle response and short pulse width control is required. State of the art Data Match Technology dynamic flow matching is used during the production of these injector sets due their large flow rate. This significantly improves the ECU’s ability to control these injectors in the sub 2ms pulse width area, typical of idle and part throttle conditions. Each injector is individually serial numbered and the results are provided on the Data Match Sheet providing the most complete flow matching and latency value information available in the industry today. Fuel Injector Clinic injectors are flow tested and rated at 43.5psi (3Bar) at 90 degrees F fuel temperature using CF-16B calibration fluid. CAUTION! The internal construction of this 2150cc/min injector includes a seal that has been found to swell when in contact with MTBE from oxygenated fuels like Q16 or VP Import. This swelling causes a significant reduction in flow through the injector and therefore renders it unsuitable for use with MTBE oxygenated fuels. Please be sure to follow the care instructions for these injectors since there are potential corrosion issues that may arise from prolonged disuse while exposed to alcohol based fuels (E85, etc.) This set of injectors requires you to change the injector plug on the wiring harness in your car. This can be done by soldering in the pigtails (included with purchase) to replace the plugs currently on your harness, or you can choose to purchase the optional plug-n-play adaptors which will convert from the type of plugs on these injectors to the plugs on your harness without any need for cutting or soldering. This plug conversion is made necessary because FIC always chooses to provide brand new, unused injectors for its performance applications.

Make

Honda

Flow rate

2150 cc/min

Set size

6 injectors

Impedance

High-Z

Aspiration

Naturally Aspirated

Injector height

53mm

Top O-ring

11mm

Bottom O-ring

21mm Square Seal

Reference pressure

43.5 psi